Changing settings from the operator panel
- 111 -
Item
Factory
default
Description
Drum Cleaning (Fn236) Off Sets to empty the drum before printing when
white streaks appear in the horizontal
direction. When [On] is set, the remaining
service life of the image drum will be
High Humid Mode Off The paper may curl when the paper is
ejected at a high humidity. Set this setting to
[Mode1] or [Mode2] to reduce the curling
effect.
Try [Mode2] if [Mode1] does not reduce the
paper curling effect.
The printing time is longer than the case of
[Off].
When [Mode1] or [Mode2] is set, the service
life of the image drum will be shortened.
Office Document Mode Mode1 In the case of Mode 1, toner is saved
according to the setting of [Admin Setup] -
[Print Setup] - [Toner Save] - [Toner Save
Level].
In the case of Mode 2, if [Toner Save Level]
is set to [Off], toner is saved by 5%. When
[Toner Save Level] is set to [Low], [Middle]
or [High], toner is saved according to the
Moisture Control Off Enables/Disables the moisture control.
When [Mode1] or [Mode2] is set, it is
possible to prevent the paper from absorbing
moisture at high humidity and prevent the
paper from getting wet. It may take much
time to print the first page.
To Next Page
Loading...
