Changing settings from the operator panel
- 113 -
*2 The values are displayed with the unit set in [Admin Setup] - [Tray Setup] - [Unit of Measurement].
Easy Setup
Item
Factory
default
Description
Enter Password ********** Input the password to enter the Easy Setup
Language
Select Language English Selects the display language of the display.
Time Setup
Sets the date in the format of yyyy/mm/dd.
Time Zone +9:00 Sets the GMT time zone.
Value range: -12:00 to +13:00 (in increments
Daylight Saving Off Sets the daylight saving (daylight saving
Setting method Manual
Selects how to set the time.
Sets the SNTP server used to set the current
date and time. Up to 64 characters can be
used.
Displayed when [Auto Config] is selected as
SNTP Server (Secondary) (Blank)
Time Setting 2001/01/01
00:00:00
The time is set at factory delivery. Change
the date and time if necessary.
Displayed when [Manual Setup] is selected
Admin
Password
Input a new admin password.
Verify Password Input the new admin password again to
Network
Setup
General
Setup
Extended Network Disable
Selected when you want to enable any other
network than the standard wired LAN.
Enabling Default Gateway Wired(LAN1)
Specifies the network connection method for
segment-based communication.
Enables/Disables the wired LAN.
NetBIOS over TCP Enable Enables/Disables the NetBIOS over TCP
Web Enable Enables the access from the web browser.
Displayed when the TCP/IP protocol is
Telnet Disable Enables the access using Telnet.
Displayed when the TCP/IP protocol is
FTP Disable Enables the access via FTP.
Displayed when the TCP/IP protocol is
IPSec Disable Displayed only when IPSec is enabled. It
can be changed to Disable only.
Displayed when the TCP/IP protocol is
SNMP Enable Enables the access from SNMP.
Displayed when the TCP/IP protocol is
Normally, [Small] is selected.
To Next Page
Loading...
