Changing settings from the operator panel
- 119 -
Item
Factory
default
Description
Normally, [Small] is selected.
Network Factory Defaults Execute Restores network menu settings to factory
Wired(LAN1)
Setup
Enables/Disables the wired LAN1.
IP Address Set Auto Set to obtain the IPv4 address automatically
IPv4 Address xxx.xxx.xxx.x
Input the IPv4 address manually. Displayed
when [IP Address Set] is set to [Manual].
Subnet Mask xxx.xxx.xxx.x
Input the subnet mask. Displayed when [IP
Address Set] is set to [Manual].
Gateway Address xxx.xxx.xxx.x
Input the gateway address. Displayed when
[IP Address Set] is set to [Manual].
DHCPv6 Disable Set to obtain the IPv6 address automatically.
Set to [Disable] when you do not use the
HUB Link Setting Auto
Sets the connection method to the hub.
USB Setup
Enables/Disables the USB interface.
Speed 480 Mbps Sets the maximum baud rate using a USB
Enables/Disables the soft reset command.
Serial Number Enable Enables/Disables the USB serial number.
The USB serial number is used to identify
the USB device connected to the PC.
Offline Receive Disable When [Enable] is selected, data can be
received even if the printer is offline.
USB Memory Interface Enable Enables/Disables the USB memory
Connected Host Normal Set to [Specific] in case of timeout when
printing is done on this machine which is in
the sleep mode.
Power consumption in the sleep mode is
higher than the state where it is set to
Print Setup Personality Auto Selects the operating language of the
Copies 1 Sets the number of copies.
The value set in the printer driver takes
Duplex On or Off
*1
Sets whether or not to implement duplex
printing.
The value set in the printer driver takes
Binding Long Edge Specifies the binding method for duplex
printing.
The value set in the printer driver takes
Media Check Enable Sets whether to check the mismatch
between the paper size of the print data and
To Next Page
Loading...
