Oki ES6450 - Page 120

Changing settings from the operator panel
- 120 -
Item
Factory
default
settings
Description
A4/Letter Override Yes Sets the functions of auto switching the
printing paper from A4 to Letter when A4
paper runs out and Letter paper is loaded, or
from Letter to A4 when Letter paper runs
out.
Resolution 600 dpi Sets the resolution.
The value set in the printer driver takes
priority.
Toner Save
Toner Save Level
Off
Sets the toner save level.
Color All Specifies whether to apply toner save to
100% black.
Mono-Print Mode Auto Sets the print mode of mono pages.
[Auto] controls the print mode with a good
balance.
[Color Mode] is suitable for printing a large
amount of color pages.
[Normal Mode] is suitable for printing a large
amount of mono pages.
Changing mono print mode(P.172)
Color Ready Mode Off Sets whether or not to prepare for the next
color printing after the printing has
completed.
Default Orientation Portrait Specifies the print orientation. For PostScript
Emulation, this setting is disabled.
Edit Size Cassette
Size
Sets the size of the drawing area when the
size is not specified by the paper size edit
command from a PC.
Trapping Off Set when white streaks appear between
adjacent colors.
X Dimension 210
millimeter
Sets the default value of paper width for
custom paper sizes.
Y Dimension 297
millimeter
Sets the default value of paper length for
custom paper sizes.
PS Setup L1 Tray Type1 Sets the tray selection number of PostScript
level-1 operator commands.
Network Protocol RAW Specifies the PS communication protocol for
network connection.
USB Protocol RAW Specifies the PS communication protocol for
USB connection.
PDF Paper Size Current Tray
Size
Specifies the paper size for direct printing of
PDF files.
PDF Scaling Size 99% Set the reduction ratio when [Scaling Size] is
selected in [PDF Paper Size].
PDF Print Mode Quality
priority
Sets whether to prioritize print quality or print
speed when a PDF is printed.
PCL Setup
Font Source
Resident2
Selects the location of the font to be used.
Font Number C1 Selects the number of the font to be used.
Value range: I0 to I90 when [Resident] is set;
or C1 to C4 when [Resident2] is set
Font Pitch 10.00 CPI Sets the PCL font width.
Value range: 0.44 to 99.99 CPI (in
increments of 0.01 CPI)