Oki ES6450 - Page 123

Changing settings from the operator panel
- 123 -
Item
Factory
default
settings
Description
Erase job option No overwrite Sets the method for erasing the print data.
Specifies that the data cannot be overwritten
after it has been erased and cannot be
restored.
If you overwrite, it will take longer to erase.
Value range: No overwrite/Zero out once
Keep job for 2hours Sets the retention period of the print data.
After the print data is saved, if the print data
is not printed after the set period, the print
data is automatically deleted.
Value range: 15 min, 30 min, 1 hour, 2
hours, 4 hours, 8 hours, 12 hours, 1 day, 2
days, 3 days, 4 days, 5 days, 6 days, 7 days
Job Limitation Enable all
print formats
Sets whether to save restricted print data.
When [Private Print only] is selected, print
data other than private print will not be
accepted.
Verify job password Off Selects whether or not to verify the
password of print data when access control
is enabled.
Job Auto Search On Selects whether or not to perform print data
search at the same time as unlocking the
panel when access control is enabled.
Color Setup Ink Simulation Off The printer comes with a built-in process
simulation tool that simulates standard
printing colors on the printer.
UCR
Low
Adjusts the degree of under color removal.
CMY100% Density Disable Selects whether to use halftone for C, M, Y
100% output.
CMYK Conversion On Selects whether to perform CMYK
conversion in the simple (high speed) mode.
Panel Setup Near Life Status Enable Sets whether to display a message when the
supplies or maintenance parts are
approaching the end of service life.
Near Life LED Enable Sets whether to light the «ATTENTION»
lamp when the supplies or maintenance
parts are approaching the end of service life.
Idle display Toner Gauge Selects the information to be displayed on
the standby screen.
Panel Contrast 0 Adjusts the contrast of the display.
Value range: -10 to +10
Buzzer Setup Error Volume Off Sets the buzzer volume when an error
occurs.
Print Completion Buzzer Volume Off Sets the buzzer volume when the printing
has completed.
AirPrint Buzzer Volume
Low
Sets the volume of the AirPrint buzzer.
Card Hold Buzzer Volume Low Sets the buzzer volume when the IC card is
held.
Displayed when access control is enabled.
Time Setup
Date Format
yyyy/mm/dd
Sets the date in the format of yyyy/mm/dd.
Time Zone +9:00 Sets the GMT time zone.
Value range: -12:00 to +13:00 (in
increments
of 15 minutes)