Oki LD670 - Page 146

145
№
Item
Explanation
Detailed setup item
5
Layout Er Process
Specifies the action to be taken if a
paper layout error occurs.
- Specify whether to clear the paper
layout error information stored in
memory.
- To continue using the same paper, do
not clear the paper layout information.
- To use a different type of paper, clear
the paper layout information.
Layout Continue
Layout Clear
6
Layout Er Recovery
Specifies the condition for recovery
from a paper layout error.
- Command transmission may be
impossible, such as because the receive
buffer is in the full state, if a paper
layout error occurs. In this case, use
Command/Cover Close instead of
Command.
Command/CoverClose
Command
7
Feed at Power On
Specifies whether to feed paper to the
start position at power-on.
- If Disable is specified and the head is
not positioned at the start position at
power-on, a print misalignment or
paper layout error may result.
Enable
Disable
8
Mark Feed with Cut
Specifies whether to cut paper after
feeding paper to the start position.
- If Enable is specified, the printer cuts
the paper that has been advanced to
the start position as triggered by a
power-on, a reset, the closing of the
cover, or the pressing of the FEED
switch. The printer does not cut the
paper that is fed to the start position
by a command.
Enable
Disable
9
Sensor Auto Adjust
Specifies whether to automatically
adjust the label and black mark
sensors when automatic setting of the
paper layout is enabled.
Enable
Disable
10
Return to Up
Returns to the selection mode for the
setup group items.
-
11
Return to Top Menu
Returns to the setup mode menu.
-