Oki LD670 - Page 147

146
(2) Memory Switch setup items
№
Item
Explanation
Detailed setup item
1
Power On Status
- Specifies reporting the power-on
state.
Enable
Disable
2
Receive Buffer
- Specifies the capacity of the receive
buffer.
45Byte
4KByte
3
Busy Condition
- Specifies the printer BUSY
condition.
Bufferfull
Offline/Bufferfull
4
Receive Error
- Specifies how to handle receive
errors
- This item is valid only for the
serial interface.
Ignore
?Print
5
Auto LF
- Specifies automatic line feed using
the CR code.
- This item is valid only for the
Parallel interface.
Enable
Disable
6
DSR(#6) Reset
- Specifies the reset operation using
the DSR (#6) signal.
- This item is valid only for the serial
interface.
Enable
Disable
7
INIT(#25) Reset
- Specifies the reset operation using
the INIT (#25) signal.
- This item is valid only for the serial
interface.
Enable
Disable
8
INIT(#31) Reset
- Specifies reset using the INIT (#31)
signal.
- This item is valid only for the
parallel interface.
Enable
Disable
9
Cover Open Error
- Specifies how to handle a cover open
error during printing.
Auto Recovery
Recovery by CMND
10
Return to Up
- Returns the menu to the selection
mode for setup group items.
-
11
Return to Top Menu
- Returns the menu to the setup mode
menu.
-