- 274 -
9. Operating Management/ Specifications
• USB Memory Setup
• TWAIN Setup
• WSD Scan Setup
•PC Scan Mode
• Scanner Adjust
Item Factory
default
setting
Description
File Name (NULL) Sets the default file name. You can enter up
to 64 characters.
The following options can be set as the
default file name.*
1
#n: adding a serial number from 00000 to
99999
#d: adding the date of a file creation
(yymmddhhmmss)
(yymmddhhmmss)
Item Factory
default
setting
Description
Network TWAIN ON Sets whether to use the Network TWAIN.
Port No.*
2
9967 Sets the port number.
Available range: 1 to 65535
Item Factory
default
setting
Description
WSD Scan Enable Specifies whether to use WSD Scan.
Binding Long Edge Bind Sets the default binding position.
Item Factory
default
setting
Description
PC Scan Mode Simple Scan
Mode
Selects the default PC scan mode.
Item Factory
default
setting
Description
Scanner Calibration Execute Executes scanner calibration.
Adjust Scan
Position
FBS Side Reg. 0 Adjusts the reading position at the document
glass and the ADF.
When the scanning result is missing the
document edge or reads the shadow of the
document edge, carry out the adjustment of
the setting value.
1 step: 0.17mm
Front Edge 0
ADF(Front-
side)
Side Reg. 0
Front Edge 0
Back Edge 0
ADF(Back-side) Front Edge 0
Back Edge 0
Adjust ADF Scan Position 0
*1
For profiles, "#n" or "#d" can be specified for [File Name].
If specifying "#n": 5-digit serial number from 00000 to 99999
If specifying "#d": Date and time when a file is created. 12-digit number in
yymmddhhmmss format
yy: Year created (the last two digits of
the Christian Era)
hh: Hours created (00 to 23)
mm: Month created (01 to 12) mm: Minute created (00 to 59)
dd: Date created (01 to 31) ss: Second created (00 to 59)
* The date and time when a file is created are values of the timer of MC563.
An example of file name specification (if the file format is PDF)
If specifying "Data#n": Saved as file names such as "Data0000.pdf" and
"Data00001.pdf".
If specifying "File#d": Saved as file names such as "File090715185045.pdf".
If specifying "Scan": "Scan.pdf" is created first, and then data is saved with the name of
"Scan#.pdf".
For "#d", refer to the above.
*2
To enable the changed setting, the network card must be restarted. Follow the
instructions on the confirmation screen that is displayed when changing the settings,
and restart the network card.
Item Factory
default
setting
Description
To Next Page
Loading...
Need help?
General
