NOTE
●
Do not store the instrument in the following locations.
–
Environments exposed to high temperature, high humidity and large amounts of dust or
particulate
–
Locations exposed to direct sunlight or radiation
–
Locations exposed to gas that includes halide
*1
Otherwise, the instrument may be damaged.
*1 The performance of some electrical parts may deteriorate due to the halide in
insecticides, pesticides and gaseous extinguishing agents, etc.
●
Do not continue to use the instrument when it is wet with condensation.
In case of a sudden temperature change, such as entering a warm room from cold outside,
condensation may be caused inside the instrument. Using the instrument while it is wet
with condensation may cause malfunction. If condensation occurs, leave the instrument in
the environment where it will be used and allow the condensation to dry before using it.
●
Do not insert the insertion tube into the inspection object which is in an environment
that exceeds the operating temperature range.
The continued use may damage or deteriorate the performance of the instrument.
●
Do not use the instrument if the contaminants are attached to the outer surface of the
instrument.
The instrument may be damaged or the performance may be deteriorated.
●
Do not cover the base unit or scope unit with a plastic bag or other objects.
The inside of the instrument may not be cooled down sufficiently, which may damage the
instrument.
●
Do not allow any liquids other than water, saltwater, machine oil or diesel oil to be
attached to the insertion tube.
Otherwise, the insertion tube may be damaged.
●
Note the following precautions when handling the battery compartment door, interface
doors, SD card door and relay cable door.
–
Do not open or close the doors when there is water on the relay cable or surrounding
surfaces.
–
Do not open or close covers with your wet hands.
–
Do not open or close covers in the area exposed to high humidity and/or dust.
–
Close covers when storing the instrument and when the terminals are not in use.
●
Note the following precautions with regard to the terminals on this unit and those on
the LED unit.
–
Do not touch the terminals directly with your hands
–
Prevent dirt and water droplets from coming in contact with the terminals.
●
Do not use this instrument when the waterproof packing inside the door of the relay
cable is damaged, cut, or misaligned.
●
Note the following precautions when taking out the instrument from the carrying case
and scope case.
–
Do not lift and pull the insertion tube.
The instrument may be damaged.
●
Do not pull the insertion tube and other cables with force or carry them around.
●
Note the following precautions when storing the instrument in the carrying case and
scope case.
–
Make sure that the distal end has cooled down sufficiently before storing it.
–
Make sure that the insertion tube is not twisted before storing it.
●
Do not lift the case when the covers of the carrying case and scope case are not closed.
●
When disposing of this product, be sure to do so in accordance with all local laws, rules
and regulations.
Before disposing of this product, check your local laws, rules and regulations, and follow
them accordingly.
7
To Next Page
Loading...
