Olympus IPLEX G Series - Using the AC Adapter; Charging the Battery

2
Using the AC adapter
Follow the steps below to connect the
AC adapter.
① Open the DC-IN terminal cap on
the base unit.
② Connect the AC power cord to the
AC inlet of the AC adapter.
③ Connect the output connector of
the AC adapter to the DC-IN
terminal of this instrument.
④ Then, connect the plug of the AC
power cord securely to a power
outlet.
3
Charging the battery
■ Charging with base unit
●
When the scope unit and AC adapter are connected to the base unit, turning off the power
starts charging the battery. (Charging is not performed when the power is on.)
●
The charging indicator appears blinking when charging is in progress.
●
If you want to stop charging halfway, disconnect the AC adapter.
●
The light of the charging indicator goes off when charging is complete.
●
Disconnect the AC adapter when the battery is fully charged.
AC inlet
DC-IN
terminal cap
27