1
Steps for stereo measurement
The following shows measurement procedures and the screen flow.
[LIVE] [LIVE]
[MEAS/OK]
[MEAS/OK]
Checking measurement values (after measurement) (See page 81)
*1
MENU/ Exit
[LIVE]
MENU/ Exit
[LIVE]
Measure the length or
the area.
Measurement screen
Measurement (See page 87)
Check the distance
from the target position
before taking
measurements.
Spot ranging screen
[MEAS/OK] or ZOOM[W]
Binocular viewMonocular view
For procedures to select
the monocular view or
the binocular view of the
live screen. (See “Using
the live screen/freeze
screen” 60 page)
Observing the measurement area
Live screen
Capturing the measurement area (See page 84)
Checking measurement values (before measurement) (See page 81)
*1
Selecting a registered
stereo optical adapter
(See page 81)
Registering/re-registering
a stereo optical adapter
(See page 76)
Attaching the stereo optical adapter (See page 75)
*1 Make sure that the measurement values obtained when “Checking measurement values
(before measurement)” and when “Checking measurement values (after measurement)” are
almost identical. If the measurement values differ from each other, check that the stereo
optical adapter is not loose and the lens is not dirty, and measure again if necessary.
75
To Next Page
Loading...
