This unit can also be used for ultraviolet (UV) and infrared (IR) light observation by replacing the
LED unit with one that is optionaly.
UV and IR light rays are not visible to the eyes, and therefore care is needed when handling
them. Make sure to follow the instructions of a professionally-trained specialist during use.
For more details on replacement of the light source unit, refer to “Replacing the LED unit”
(page 94)
. Also, when a UV or IR LED unit is connected, a confirmation screen will appear when
you turn on the power of this unit. Press “OK” and use this unit according to the basic procedures.
7-1 Replacing the LED unit
● Removal
1 Turn of the power.
2 Loosen the 4 bolts on the scope unit with a hexagonal wrench (comes supplied with
the optional LED unit).
3 Remove the LED unit.
IPLEX G
77
77
7
7
7
7
7 Observation of special light
94
To Next Page
Loading...
