9 After the message below appears, remove the optical data media from the SDHC
card slot, select “OK” and press the [MEAS/OK] joystick.
“REMOVE THE OPTICAL DATA MEDIA.”
Place the optical data media (SDHC card) in the optical adapter case to prevent it from
being misplaced.
10 Check the measurement values.
After registering the stereo optical adapter, it is necessary to check the measurement values.
See “Checking measurement values” (page 82) for details about operations.
TIP
After registration of the stereo optical adapter is complete, a file named “IV7CALIB/
FREEZE.JPG” is created in the optical data media. Deleting this file will not affect operation
of this unit.
■ Re-registering a stereo optical adapter
Re-register a stereo optical adapter following the same steps as “Registering a new stereo optical
adapter” (page 77).
81
To Next Page
Loading...
