2.3 Inside
23
OER-Elite INSTALLATION MANUAL
Ch.2
2.3 Inside
No. Nomenclature Description
1 Gas filter case (tank) Accommodates the gas filter for removing the odor and vapor of the disinfectant
solution.
2 Ventilation opening on the
gas filter case
This is the hole for taking and exhausting air into/from the disinfectant solution
tank. Do not block the ventilation openings on the gas filter cases.
3 Disinfectant solution tank
window
Used to check the amount of remaining disinfectant solution.
4 Accessory holder Used to store the connecting tubes, etc.
5 Disinfectant removal port Used to remove the residual disinfectant solution in the tank by using the
disinfectant removal tube.
It is also used to withdraw the amount of disinfectant solution by using the drain
connector for detergent/alcohol piping disinfection.
(Remove the rubber cap and attach the drain connector or the disinfectant
removal tube.)
6 Maintenance terminal Used for connecting ancillary equipment (for trained service personnel only).
7 Water tray Collects water during maintenance such as the water filter replacement.
8 Air filter Accommodates the 0.2-micron air filter.
9 Connector below water
filter housing
For use in draining water from the water filter housing.
10 Water filter (housing) Accommodates the 0.2-micron internal water filter.
11 Connector above water
filter housing
For use in draining water and air from the water filter housing.
1
2
3
4
56
7
8
9
10
11
To Next Page
Loading...
