14
Outline of Functions
OER-Elite INSTALLATION MANUAL
Following functions are available in this device.
Reprocessing
A series of operations that enable the equipment to perform ultrasonic cleaning, detergent
cleaning, disinfection, rinse, air purge, and alcohol flush. A series of operations for ultrasonic
cleaning, detergent cleaning, disinfection, rinse, air purge, and alcohol flush of the outer surface
and channels of endoscopes in a specified sequence and for a specified time. Reprocessing
programs [1] to [4] can be selected by the user. Programs [1] to [4] have a fixed cleaning
process time and disinfection process time. They also have different patterns of auto leak test
and channel monitoring respectively. For details, refer to Chapter 6, “Reprocessing Operations”
in “Instructions-Operation manual”.
Drain LCG
This function drains the disinfectant solution from the disinfectant tank. For details, refer to
Section 8.2, “Replacing the disinfectant solution” in “Instructions-Operation manual”.
Load LCG
This function loads the disinfectant solution by setting a new disinfectant bottle. For details, refer
to Section 8.2, “Replacing the disinfectant solution” in “Instructions-Operation manual”.
Heat LCG
A process for heating disinfectant solution until it reaches the specified temperature. This
process is performed automatically during the reprocessing program. It can also be performed
as an independent operation. For details, refer to Section 7.2, “Heat LCG” in
“Instructions-Operation manual”.
Heat LCG Timer
The function for heating the disinfectant solution until the specified temperature by the specified
time. For details, refer to Section 7.3, “Heat LCG Timer” in “Instructions-Operation manual”.
Mix LCG
This function is mixing the disinfectant solution to the appropriate concentration concentration
and enables accurate concentration check.
Outline of Functions
To Next Page
Loading...
