3.3 Installation of the buckling guard
39
OER-Elite INSTALLATION MANUAL
Ch.3
The buckling guard helps maintain proper drainage by preventing the drain hose from being crushed if
the instrument is pushed too close to a wall, etc.
Be sure to securely attach the buckling guard using the buckling guard retaining
screws. If the screws are not properly attached, the buckling guard may become
detached, allowing the drain hose and power cord to be pinched against the wall
and causing problems such as water discharge failure.
Align the holes on the buckling guard with the screw holes threaded on the rear panel and attach using
the three buckling guard retaining screws.
Figure 3.2
3.3 Installation of the buckling guard
Bucking guard
To Next Page
Loading...
