3.10 Installation of the optional accessories
45
OER-Elite INSTALLATION MANUAL
Ch.3
Connection of the bar code reader (MAJ-2130)
If the optional bar code reader (MAJ-2130) is connected to the equipment, the patient ID can be
entered by the bar code reader. For details, refer to “ Entering the patient ID by the optional bar code”
in Section 3.6, “Entering ID” in “Instructions-Operation Manual”.
To install the bar code reader (MAJ-2130), refer to Chapter 3, “Installation and Connection” in
“MAJ-2130 Instruction Manual”.
• Do not stare into beam. It may cause damage to the eyes.
• Do not irradiate people’s eyes with beam. It may cause damage to the eyes.
• Do not connect any other equipment with the bar code reader port except the bar
code reader itself (MAJ-2130). Otherwise, the bar codes may not be scanned
correctly. Also, equipment failure or burnout may result.
• The communication cable should not be sharply bent, pulled, twisted, or crushed.
Cable damage can result, and bar codes may not be properly scanned.
Connecting diagram
Figure 3.8
3.10 Installation of the optional accessories
Bar code reader
Bar code reader port
Communication cable
To Next Page
Loading...
