58
4.4 Connection of the water supply hose
OER-Elite INSTALLATION MANUAL
Ch.4
The water supply plug of this equipment is designed to be connected to an ordinary tap water faucet
with 3/4” GHT (garden hose thread), or the Olympus Pre-Filter Assembly (MF01-0033PL). If a different
type of the water faucet is used, have a plumber enable a safe and secure connection.
4.4 Connection of the water supply hose
1 Make sure that there is a packing inside of the
water supply plug.
Figure 4.2
2 Fit the water supply plug onto the water faucet
and turn it clockwise to tighten with the
provided wrench. The pitch of the thread of the
water supply plug is “3/4” garden hose thread
(GHT).
Figure 4.3
3 While pushing a finger against the lock lever on
the water supply socket, pull the sleeve down
toward the hose and fit the socket onto the
water supply plug. Release the lock lever
ensuring that it hooks onto the outer ring of the
plug as pictured in Figure 4.4.
Figure 4.4
Packing
(1)
(3)
(2)
To Next Page
Loading...
