44
3.8 Inspecting the accessory holder
OER-Elite INSTALLATION MANUAL
Ch.3
Check if the accessory holder is attached securely with two screws to the inner side of the front door as
shown in Figure 3.7. Check by turning the screws clockwise with your hands, and tighten them if they
are loose.
3.8 Inspecting the accessory holder
3.9 Storing other accessories
1 Accessories such as the connecting tubes can
be hung on the accessory holder on the inner
side of the front door. After reprocessing the
accessories ensure that they are completely
dry before storing them.
Figure 3.7
2 Put the scope ID master card and user ID master card in the card holders and attach
the card holder below the accessory holder on the inner side of the front door.
3 Less frequently used accessories should be dried completely and then stored
together in a place not exposed to dust or direct sunlight.
Accessory
holder
To Next Page
Loading...
