3.1 Installation of accessories workflow below
37
OER-Elite INSTALLATION MANUAL
Ch.3
Chapter 3 Installation of Accessories
Set up the equipment and ancillary equipment as required while referring to the “System chart” in the
“Instructions-Operation Manual”. Also, refer to the instruction manual for the ancillary equipment and
follow the instructions below to install and connect the equipment and ancillary equipment.
See the installation of accessories workflow below.
3.1 Installation of accessories workflow below
1
Install the grommets.
Section 3.2 on page 38
2
Install the bucking guard.
Section 3.3 on page 39
3
Inspect the mesh filter.
Section 3.4 on page 40
4
Inspect the retaining rack.
Section 3.5 on page 41
5
Install the washing case (MAJ-2121).
Section 3.6 on page 42
6
Install the stylus pen holder.
Section 3.7 on page 43
7
Inspect the accessory holder.
Section 3.8 on page 44
To Next Page
Loading...
