1
Introduction
Drive Programming User’s Manual (I580-E2)
Introduction
Thank you for purchasing the Inverter/Servo support tool CX-Drive and 3G3MX2/3G3RX/3G3LX Series
Inverter.
This manual describes the specifications and operating methods of the Drive Programming for the
inverter.
When you use this product, refer to the MX2 Series User's Manual (I570-E2) or the RX User's Manual
(I560-E2), besides the CX-Drive Operation Manual (W453).
This manual is intended for the following personnel, who must also have knowledge of electrical sys-
tems (an electrical engineer or the equivalent).
• Personnel in charge of introducing FA systems.
• Personnel in charge of designing FA systems.
• Personnel in charge of installing and connecting FA systems.
• Personnel in charge of managing FA systems and facilities.
This manual contains information you need to know to use the Drive Programming.
Before using this product, read this manual and gain a full understanding of the information provided
herein.
After you finished reading this manual, keep it in a convenient place so that it can be referenced at any
time.
Make sure this manual is delivered to the end user.
Intended Readers
Notice
To Next Page
Loading...
Need help?
General