Omron CP1L CPU - SECTION 4 Creating Programs; 4-1 Preparing for Programming; 4-2 Creating Ladder Programs; 4-3 Using CX-Programmer

SECTION 4
Creating Programs
In this section, the steps for creating ladder programs essential to
CP1L operation will be shown, using CX-Programmer. In creating
the ladder program for the shutter control system, the basic
functions of CX-Programmer will be explained.
4-1 Preparing for Programming................................................... 38
4-1-1 What is CX-Programmer? .............................................. 38
4-1-2 Connecting to a Computer
and Installing the USB Driver ......................................... 39
4-2 Creating Ladder Programs ................................................... 44
4-2-1 Operation........................................................................ 44
4-2-2 Ladder Program.............................................................. 46
4-3 Using CX-Programmer.......................................................... 47
4-3-1 Starting CX-Programmer ................................................ 47
4-3-2 Operation Screens.......................................................... 48
4-4 Using the Help ...................................................................... 50
4-5 Inputting Programs ............................................................... 53
4-5-1 Creating New Projects.................................................... 53
4-5-2 Inputting Contacts........................................................... 56
4-5-3 Inputting Output Coils ..................................................... 59
4-5-4 Inputting Timers .............................................................. 61
4-5-5 Inputting Counters .......................................................... 63
4-5-6 Inputting Auxiliary Areas................................................. 66
4-5-7 Inputting Differentiated Up Contacts............................... 68
4-5-8 END Instruction .............................................................. 69
4-6 Saving/Loading Programs .................................................... 70
4-6-1 Compiling Programs ....................................................... 70
4-6-2 Saving Programs ............................................................ 71
4-6-3 Loading Programs .......................................................... 72
4-7 Editing Programs .................................................................. 73
4-7-1 Editing I/O Comments .................................................... 73
4-7-2 Inputting Rung Comments.............................................. 74
4-7-3 Editing Rungs ................................................................. 75
W07E-EN-02+CP1L+GettingStartedGuide.book Seite 37 Montag, 15. September 2008 11:15 11