5-2 Adjusting/Debugging Online
5
5
88 SYSMAC CP1L Getting Started Guide
Transferring and Debugging Programs
5-2-2 Force-Setting/Force-Resetting
CX-Programmer can control inputs, independent of inputs from I/O devices. Use
this function to force input conditions and output conditions during test runs.
Note Before force-setting/force-resetting/releasing or setting/resetting, confirm that the
facility will not be affected.
The force-setting procedure is as follows.
1. Change CP1L to the MONITOR or PROGRAM operating mode.
2. Place the cursor on the contact to force-set.
W07E-EN-02+CP1L+GettingStartedGuide.book Seite 88 Montag, 15. September 2008 11:15 11
To Next Page
Loading...
