Omron E5CN User Manual

155
Operation Level Section 5-3
This parameter starts and stops the simple program function.
• The RUN/STOP status will automatically switch to RUN when this param-
eter is set to STRT.
• The simple program will stop when this parameter is set to RSET.
• This parameter will function as a monitor display for the start/stop status
of the simple program if an event input is selected to start the simple pro-
gram.
■ Related Parameters
Soak time remain: Page 155, RUN/STOP: Page 156 (operation level)
Soak time, Wait band (adjustment level): Page 175
Program pattern (initial setting level): Page 189
Soak time unit (advanced function setting level): Page 224
• This parameter measures and displays the remaining time of the soak
time for the simple program function.
■ Related Parameters
Program start (operation level): Page 155
Soak time, Wait band (adjustment level): Page 175
Program pattern (initial setting level): Page 189
Soak time unit (advanced function setting level): Page 224
prst Program Start
The Program Pattern parameter
must not be set to OFF.
Setting range Default
RSET Stops the simpler program. rset
STRT Starts the simpler program.
Function
Operation
See
See
sktr Soak Time Remain
The Program Pattern parameter
must not be set to OFF.
Monitor range Unit
0 to 9999 min or h
Function
Monitor
See
See

Omron E5CN Specifications

General

Communication	RS-485 (optional)
Mounting	Panel Mount
Control Method	ON/OFF
Input Type	Thermocouple, RTD
Supply Voltage	100 to 240 VAC
Output Type	Relay, Voltage (for driving SSR), Current
Display Type	7-segment LED
Size	48 x 48 mm
Control Output	Relay, Voltage (for driving SSR), Current
Alarm Output	1 or 2 outputs
Dimensions	48 x 48 x 78 mm
Ambient Operating Temperature	-10 to 55°C
Protection Rating	IP66