Omron E5CN User Manual

156
Operation Level Section 5-3
This parameter starts and stops the control operation.
When run (RUN) is selected, control is started. When stop (STOP) is
selected, control is stopped. The STOP indicator will light when control.
The default is run.
This parameter will not be displayed if an event input is set to “RUN/STOP.”
This parameter is set to one of the input values “X” in the alarm type list.
• This parameter sets the alarm value for alarm 1.
• During temperature input, the decimal point position depends on the cur-
rently selected sensor, and during analog input it depends on the Decimal
Point parameter setting.
■ Related Parameters
Input type: Page 184, Scaling upper limit, Scaling lower limit, Decimal point
(initial setting level): Page 186 (initial setting level)
Alarm 1 type (initial setting level): Page 191
Standby sequence reset: Page 202, Auxiliary output * open in alarm: Page
203, Alarm 1 hysteresis: Page 192, Alarm 1 latch: Page 208 (advanced func-
tion setting level)
r-s RUN/STOP
The Event Input Assignment 1 and 2
parameters must not be set to “RUN/
STOP.”
Operation
See
See
al-1 Alarm Value 1
Alarm 1 must be assigned.
The alarm 1 type must not be 0, 1, 4,
5, or 12.
Setting range Unit Default
−1999 to 9999 EU 0
Function
Setting
See
See

Omron E5CN Specifications

General

Communication	RS-485 (optional)
Mounting	Panel Mount
Control Method	ON/OFF
Input Type	Thermocouple, RTD
Supply Voltage	100 to 240 VAC
Output Type	Relay, Voltage (for driving SSR), Current
Display Type	7-segment LED
Size	48 x 48 mm
Control Output	Relay, Voltage (for driving SSR), Current
Alarm Output	1 or 2 outputs
Dimensions	48 x 48 x 78 mm
Ambient Operating Temperature	-10 to 55°C
Protection Rating	IP66