Omron fh series Hardware Manual

5 - 27
5 Setup and Wiring
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
5-4 Setup Touch Panel Monitor or Monitor
5
5-4-3 FH-L Series
Precautions for Safe Use
• Please insert monitor connector perpendicularly so that the connector resin part and pin are
not rubbing against each other. Damaged pin may cause contact failure due to generation
and invasion of resin powder.
• When you connect FH-L series to the FH-MT12 via USB cable:
Do not ground the positive terminal of DC24V power source. The internal circuit is possible to
be given damage, it can be cause the failure.
Precautions for Correct Use
When connecting the sensor controller and monitor with a switcher and splitter
Do not use devices that make the Sensor Controller recognize the monitor again when switch-
ing operation is performed. Re-recognition process in switching operation has an effect such as
a delay in measurement time.
When fix the DVI connector
If difficult to fix the bilateral screws of DVI connector, once loosen these. Then retry to fix, again.
5-4-3 FH-L Series

Omron fh series Specifications

General

Type	Machine Vision System
Series	FH Series
Power Supply	24 VDC
Storage Temperature	-20 to 60°C
Humidity	35 to 85% RH (non-condensing)
Image Sensor	CMOS
Processing Speed	High-speed processing
Connectivity	Ethernet
I/O	Digital I/O
Operating System	Embedded OS
I/O Ports	Ethernet, USB