Omron fh series Hardware Manual

5 Setup and Wiring
5 - 30
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
Precautions for Safe Use
Ground
When the connected camera to the Sensor Control comes packaged with a base, make sure to
mount with the base.
Since the enclosure of the camera main body made of metals is short-circuited with the internal
circuit, the internal circuit might be short-circuited with FG if no base is used, so that failures or
malfunctions may be caused.
Connect the FH-1000/FH-3000 series Sensor Controller to the FH-SC12 / FH-SN12:
12 megapixels camera
When you connect FH-L series to the FH-SC12 or FH-SM12:
Do not ground the positive terminal of DC24V power source. The internal circuit is possible to
be given damage, it can be cause the failure.
Secure the minimum bending radius of the cable or cable connector.
Precautions for Safe Use
When the connected camera to the Sensor Control comes packaged with a base, make sure to
mount with the base.
Since the enclosure of the camera main body made of metals is short-circuited with the internal
circuit, the internal circuit might be short-circuited with FG if no base is used, so that failures or
malfunctions may be caused.
5-5-3 FH-L Series
Camera cable mounting
5-5-4 FZ5 Series
Minimum bending radius

Omron fh series Specifications

General

Brand	Omron
Model	fh series
Category	Machine Vision Systems
Language	English