Omron fh series Hardware Manual

Regulations and Standards
24
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
This regulation applies to FH-L series Sensor Controller and peripheral devices.
The FH-L series Sensor Controller is compliant with the standards below:
• EC Directive 2004/108/EC (Until April 19 2016) / EU Directive 2014/30/EU (After April 20 2016)
EN61326-1
Electromagnetic environment: Industrial electromagnetic environment (EN/IEC 61326-1 Table 2)
• Also, the following condition is applied to the immunity test of this product.
• If the level of disturbance of the video is such that characters on the monitor are readable, the test
is a pass.
• This product complies with EC/EU Directives. EMC-related performance of the OMRON devices that
comply with EC/EU Directives will vary depending on the configuration, wiring, and other conditions
of the equipment or control panel on which the OMRON devices are installed.
• The customer must, therefore, perform the final check to confirm that devices and the overall
machine conform to EMC standards.
• If there is a need to respond to the EC / EU directive, please use by an analog RGB output.
This regulation applies to FH-L series Sensor Controller and peripheral devices.
This product complies with UL Standards.
• UL 61010-2-201
FH-L series
Conformance to EC/EU Directives
Conformance to UL Standards

Omron fh series Specifications

General

Type	Machine Vision System
Series	FH Series
Power Supply	24 VDC
Storage Temperature	-20 to 60°C
Humidity	35 to 85% RH (non-condensing)
Image Sensor	CMOS
Processing Speed	High-speed processing
Connectivity	Ethernet
I/O	Digital I/O
Operating System	Embedded OS
I/O Ports	Ethernet, USB