Omron G9SX - Reset Mode

Wiring and SetupSection 3
2. Functions, Wiring and Settings
62
G9SX
USER'S GUIDE
2-3 Reset Mode
Set the reset mode using feedback/reset input terminals T31, T32, and T33.
Reset mode Wiring Function summary
Auto reset mode
The signal to terminal T33 must be ON for the
safety output to turn ON.
If terminal T33 is not ON, the safety output will
not turn ON.
Manual reset mode
The signal to terminal T32 must turn ON and then
OFF for the safety output to turn ON.
If terminal T32 does not turn ON and then OFF,
the safety output will not turn ON.
+24 V
KM1
KM2
KM3
KM4
KM5
T33T32T31
Feedback Loop
KM1
KM2
KM3
KM4
KM5
T33T32T31
Feedback Loop
+24 V
Reset
switch