3 Functions of NB-Designer
3-108
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
2
Switch to the [Moving Component] tab and set the Type, State Number, the Minimum of X,
Maximum of X, Minimum of Y and Maximum of Y.
Type and Function Tables:
NB-Designer can assign up to 256 kinds of different states to the components. When State
Number is set to "1" in the tab [Moving Component], make sure that the stored value specified
to the [Read Address] is 0. Otherwise, the components will not be displayed, States 1 to 256
correspond to the internal values of 0 to 255. The position control is as shown below, and its
position is relative to the original position (X-axis and Y-axis represent abscissa and ordinate
respectively.)
The Type includes the items as follows.
Control Mode X Y X & Y
Number of Read
Address
2 words 2 words 3 words
Read Address States of Vector Graphics
or bitmap
States of Vector Graphics
or bitmap
States of Vector Graphics
or bitmap
Read Address + 1 X-axis displacement Y-axis displacement X-axis displacement
Read Address + 2 - - Y-axis displacement
To Next Page
Loading...
Need help?
General
