3 Functions of NB-Designer
3-242
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
4
Later you can use it in the other places, as shown below.
Note 1 The addresses having been logged in the Variable Table can’t be changed in the other places, that’s to say,
they can only be used. If they are needed to be changed, you just need to enter the Variable Table dialog
box to change the address.
2 Note the following points when using the Variable.
The Variable specified [Bit] for the [Memory Type] can be allocated only to the bit state component. Also
the Variable specified [Word] for the [Memory Type] can be allocated only to the word state component.
To Next Page
Loading...
