3-303
3 Functions of NB-Designer
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
3-10 System Parameters
3
3-10-6 User Permission Setting
For example:
(1) For the User Permission Setting of User 0: Check the [Enabled] option and set the User
Name to Administrator, Password to 666666 and Logout Time to 1 minute. Assign 4
Authorities, i.e. Operation Permission, Process Permission, System Config Permission and
Add/Delete User Permission respectively for the “Administrator (User 0)”.
(2) For User Permission Setting of User 1: Check the [Enabled] tab and set the User Name to
Engineer, Password to 222222 and Logoff Time to 10 minutes. Assign 1 Authority, i.e.
Process Permission to the “Engineer (User 1)”.
Besides the User Permission Setting in PT Property, using the following internal memory
allows the operations concerning the user permission.
2
Dynamically Add/Delete User Permission during operations.
Perform adding or deleting the user permission during operations in the PT. The following
internal memory is used for adding or deleting the user permission during operations.
Addresses Functions Descriptions
LW9486~LW9501 Input the login user name. 32 characters max.
LW9502~LW9503 Input the password corresponding
to the login user.
Double-word
LW9504~LW9505 Display the current user authority. Double-word, read-only component, the
corresponding 32 authorities.
LB9165 Execute the user login. After it is turned ON, the login operation is
performed, and later it is turned OFF automatically.
LB9166 Execute the user logout. After it is turned ON, the logout operation is
performed, and later it is turned OFF automatically.
To Next Page
Loading...
Need help?
General
