3-41
3 Functions of NB-Designer
NB-series Programmable Terminals NB-Designer Operation Manual(V106)
3-3 NB-Designer Software Window
3
3-3-3 Project Work Space
An example of setting addresses for [Current PLC] and [New PLC] are as follows.
• Supporting PT Model Replacement
Note PT replacement must be carried out through the [Change PT Model] option. If you do not use this
function and delete all the settings of PLC to reconnect with the new PLC, the PLC area is replaced with
all the local addresses of PT.
When the PT needs to be replaced, you can select the PT by right-clicking it in the Configuration and
Setup Window, and select “Change PT Model” in the pop-up menu.
To Next Page
Loading...
Need help?
General
