Omron NX102-12 Series - Page 502

Connection status
Source of error
Handling
General
Status
(hex)
Additional
Status
(hex)
Configuration
1
Configuration
2
Configuration
3
01 0315 Error code returned from target:
There was a parameter error in the
frame used to open the connection.
This error does
not occur
.
Depends on
the target's
specifications.
(Contact the
target device's
manufacturer.)
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
01 0316 Error code returned from target:
There was a parameter error in the
frame used to close the connection.
This error does
not occur
.
Depends on
the target's
specifications.
(Contact the
target device's
manufacturer.)
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
01 031C Error code generated by originator:
Some other error occurred.
This error does
not occur
.
The originator
generates this
code when an
unsupported
response code
is returned
from the target
in reply to an
open request.
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
08 --- Error code returned from target:
There is no Forward Open or Large For-
ward Open service in the target device.
This error does
not occur
.
Depends on
the target's
specifications.
(Contact the
target device's
manufacturer.)
Depends on
the originator's
specifications.
(Contact the
originator devi-
ce's manufac-
turer.)
16 Troubleshooting
16-16
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)