Clear the selection of the Do not transfer the EtherNet/IP connection settings (i.e., tag data
link settings) Check Box, and then click the Execute Button.
Precautions for Correct Use
To transfer only the connection settings, execute Transfer from the EtherNet/IP Connection Set-
ting T
ab Page.
Even if you clear the Do not transfer the connection setting Check Box, the connection set-
tings are not transferred from the Synchronization Window, the Transfer to Controller Dialog
Box, or the Transfer from Controller Dialog Box as long as the data in the computer is
synchronized with the data in the Controller.
Transferring Only the EtherNet/IP Connection Settings
You can transfer tag sets and connections to the EtherNet/IP devices.
1 Establish an online connection with the Controller.
2 Click the T
ransfer to Controller or Transfer from Controller Button in the EtherNet/IP Con-
nection Setting Tab Page.
The tag settings and connection settings set at that time are transferred to the Controller con-
nected online.
3 If the Controller connected online is in RUN mode, the dialog box to confirm whether to switch
to PROGRAM mode before transferring the settings is displayed.
Appendices
A-28
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
To Next Page
Loading...
Need help?
General
