Omron NX1P2 series

l
Removing Wires
Use the following procedure to remove the wires from the terminal block.
The removal method is the same for ferrules, twisted wires, and solid wires.
If wires are secured firmly to the terminal block, release them first.
1 Press the a flat-blade screwdriver straight into the release hole.
If you press in the screwdriver correctly, you will feel the spring in the release hole, and the
screw driver will begin to incline.
1
Wire
Flat-blade screwdriver
2 Leave the flat-blade screwdriver pressed into the release hole and pull out the wire.
2
3 Remove the flat-blade screwdriver from the release hole.
3
5 Installation and Wiring
5-60
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)