Omron NX1P2 series Hardware User Manual

5-4
Wiring
WARNING
• Do not input a voltage or current that exceeds the specified range into a Unit or
slave. If a voltage or current that is outside the specified range is input, the Unit or
slave may fail or a fire may occur
.
Caution
• Tighten terminal block screws and cable screws to the torques specified in this
manual or in the reference manuals. Loose screws may result in fire or malfunction.
•
Do not touch devices while power is supplied or immediately after the power supply
is turned OFF
. You may get burnt.
Precautions for Safe Use
Use the methods that are specified in this manual for wiring the terminal blocks.
Precautions for Correct Use
Do not allow wire clippings or shavings to enter any Unit. Otherwise, Unit burning, failure, or
malfunction may occur. Cover the Units or take other suitable countermeasures, especially dur-
ing wiring work.
5 Installation and Wiring
5-43
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)
5-4 Wiring
5

Omron NX1P2 series Specifications

General

Model	NX1P2 Series
Manufacturer	Omron
Type	Controller
CPU Units	1
Program Capacity	5 MB
Data Memory Capacity	128 KB
Ethernet Ports	1
Serial Ports	1
Built-in EtherNet/IP Port	Yes
Built-in EtherCAT Port	Yes
Built-in USB Port	Yes
SD Memory Card Slot	Yes
USB Port	1
Power Supply Voltage	24 VDC
Programming Language	Ladder, Structured Text, Function Block Diagram
Communication Protocols	EtherNet/IP, EtherCAT, Serial (RS-232C)