262
GRT1-CP1-L Positioning Unit Section 7-5
Setting Special
Positioning Unit
Functions
Positioning Unit functions are set using the Edit Unit Parameters Window. The
procedure for accessing the Edit Unit Parameters Windows depends on the
Support Software that is being used. The procedure for DeviceNet Configura-
tor (version 2.43 or higher) is given below as an example.
1,2,3... (1) Open the Network Configuration Window in the DeviceNet Configurator.
(2) Double-click the desired Slice I/O Terminal's icon or right-click the icon
and select Parameters - Edit to display the Edit Device Parameters Win-
dow shown below.
(3) Select the desired Positioning Unit from the list on the I/O Module Tab
Page and click the Edit Button. The Edit Unit Parameters Window will be
displayed as shown below.
To Next Page
Loading...
