What to do if Omron I/O Systems output cannot be held when a communications error or bus error occurs?
If the output cannot be held when a communications error or bus error occurs in Omron I/O Systems, set the Unit's Output Hold/Clear setting to hold outputs when a communications error or bus error occurs.
Why is the Unit Power LED flashing on my Omron SmartSlice GRT1 Communications Unit?
If the Communications Unit’s Unit Power LED is flashing, it indicates that you may need to check the entire Slice I/O Terminal’s power supply requirement and replace the power supply with one that has sufficient capacity.
What to do if Omron I/O Systems restore operation failed?
If the restore operation failed in Omron I/O Systems, reinstall the Unit in which the data was being restored and turn the power ON again.
What to do if Omron I/O Systems parameter data is invalid?
If the parameter data is invalid in Omron I/O Systems, use a Programming Device to write the correct data again.
What to do if Omron I/O Systems backup data is invalid?
If the backup data is invalid in Omron I/O Systems, backup the data again.
What to do if Omron I/O Systems backup operation failed?
If the backup operation failed in Omron I/O Systems, backup the data again.
How to fix Omron I/O Systems when registration table data is invalid?
When the registration table data is invalid in Omron I/O Systems, register the I/O configuration table again.
What to do if Omron I/O Systems outputs are actually OFF, but the output indicators on the Digital Output Units are ON?
If the output indicators on the Digital Output Units are ON while the outputs are being sent from the Master Unit, but the outputs are actually OFF in Omron I/O Systems, check the Slice I/O Units and make sure that each one is connected properly to the adjacent Units.
What to do if there is a node address duplication error at another Unit in the DeviceNet network of Omron I/O Systems?
If there is a node address duplication error at another Unit in the DeviceNet network of Omron I/O Systems, set the node addresses again to eliminate the duplication, and restart the Slice I/O Terminal.
What to do if Omron I/O Systems Slice I/O Unit configuration error occurred?
If a Slice I/O Unit configuration error occurred in Omron I/O Systems, check the following items: * Are more than 64 I/O Units connected? * Are more than 128 bytes of I/O data being used? * Has the I/O configuration changed since the I/O configuration table was registered?
General| Brand | Omron |
|---|---|
| Model | SmartSlice GRT1 Series |
| Category | I/O Systems |
| Language | English |
To Next Page