1500 North Belcher Road, Clearwater, FL 33765 • Tel (727) 447-6140 • Fax (727) 442-5699 • sales@onicon.com
D-100 Flow Display Manual 08/12 - 0634-7 Page 22
4.3 UNITS AND MULTIPLIERS
The operating mode, engineering units and multipliers are programmed into the D-100 at the
factory. These settings may be re-programmed in the eld. Please contact ONICON for assistance
if changes are required.
4.4 ANALOG OUTPUTS
The D-100 is capable of providing up to four analog outputs (optional). Changing any of the
displayed units or multipliers will affect the analog outputs. If any unit or multiplier values are
changed at the D-100, the analog output value(s) will also be changed. If you are unsure of the
ramications of any changes you are contemplating, please contact ONICON for assistance.
4.5 ENABLING / DISABLING FRONT PANEL RESET
The table below explains how to enable or disable the FRONT PANEL RESET.
STEP ACTION REACTION COMMENT
1 With the display running, open the
frontpanelandlocateDEVADD/
PROGENAB.PressDEVADD/PROG
ENAB and then release it.
None DEVADD/PROGENABis
located in the lower left
corner of the processor
board. (see appendix page
A-2.)
2 Close the front panel.
3 Press the PROGRAM button. (If you
do not press the PROGRAM button,
the meter will revert to the run mode
after ve minutes.)
The display changes to
program mode and the
DEVICEIDpagewillappear
with the rst digit of the
address ashing.
The PROGRAM button is
on the front panel.
4 Press the PROGRAM button. The FRONT PANEL RESET
page appears with the N or
Y ashing.
5 Press the SCROLL button. The setting will toggle
between N and Y.
Enable or disable the
FRONT PANEL RESET as
necessary.
6 Press the PROGRAM button. TheSAVECHANGESpage
appears with the N ashing.
The new FRONT PANEL
RESET setting must be
saved to take effect.
7 Press the SCROLL button. The N changes to Y. The Y must be selected for
the change to take effect.
8 Press the PROGRAM button. The new setting is saved
and the display reverts to
the run mode.
To Next Page
Loading...
