EasyManuals Logo

Onicon D-100 User Manual

Onicon D-100
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
1500 North Belcher Road, Clearwater, FL 33765 Tel (727) 447-6140 • Fax (727) 442-5699 sales@onicon.com
D-100 Flow Display Manual 08-12 - 0634-7 Page 7
1.4 ADDITIONAL REQUIRED HARDWARE
Flow Meter
ONICON offers a wide variety of ow meters to satisfy most liquid, gas and steam
metering applications. Please refer to ONICON’s ow meter literature, or consult
ONICON or your local representative for help in selecting the ow meter that will best
t your requirements.
1.5 WORKING ENVIRONMENT
The D-100 was designed for installation and use in typical industrial environments that are
free of corrosive liquids and fumes, direct liquid exposure, heavy condensation, temperature
extremes, direct sunlight, and vibrations. The operating ambient air temperature range is -20° F
to 140° F. Electrical power should be relatively clean, free of high frequency noise, large voltage
transients, and protected from power surges and brown-outs.
1.6 WARRANTY & SERIAL NUMBER
Warranty
ONICON’s 2-year “No-fault” warranty reduces start-up costs by extending coverage for
incidental damage during installation. Certain exclusions apply. Please refer to ONICON’s
Conditions of Sale for details.
Serial Number
The serial number of your D-100 is located outside and inside the enclosure. Also located
inside the enclosure is a label with the serial number of the associated ONICON ow
meter or sensor your D-100 was intended to be used with. The serial numbers are unique
identiers that you should have available when contacting ONICON for assistance
regarding the installation or use of this product.
SECTION: 2.0 UNPACKING
The D-100 is shipped in one package unless optional hardware or equipment is ordered. Notify the
freight carrier (normally, products are shipped insured.) and ONICON if any items are damaged in
transit.
NOTE: Flow meters are packed separately.
2.1 CHECKING THAT YOU HAVE RECEIVED EVERYTHING
• Standard Documentation
Enclosed with each D-100 is a comprehensive documentation package that includes the
following items:
The D-100 Installation and Operation Guide
The D-100 Conguration Data Sheet
Please notify ONICON if any of these items are missing.
i
IMPORTANT NOTE
The ONICON D-100 is delivered fully programmed and ready to use with a specic ow meter.
The serial number of the ow meter and any other sensor used with this D-100 will be found on
a label located inside the enclosure. Do not attempt to use the D-100 with any other ow meter
or sensor. Doing so will result in signicant errors in the ow reading.

Table of Contents

Other manuals for Onicon D-100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onicon D-100 and is the answer not in the manual?

Onicon D-100 Specifications

General IconGeneral
BrandOnicon
ModelD-100
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals