Onkyo TX-8470

86
SetupSetup
5. Works with SONOS5. Works with SONOS
Change the settings to connect with the Sonos Port.
(SONOS-1/SONOS-2)
 Input Selector (Default Value: O󰀨)
Select the input selector to which the Sonos Port is connected.
• 󰀨
 Connected Device (Default Value: -)
Displays the Sonos Port connected to the same network as the network of this
unit. Press the ENTER button to select the connected Sonos Port.
• Products (e.g. Play:3 unequipped with an output terminal) other than the
Sonos Port are also displayed in the device list and selectable. In that case,
when playback on the Sonos side starts, the input is switched, however,
audio is not output. Select the room name of the connected Sonos Port.
• Up to 32 devices can be displayed on the Sonos product list screen. If you

󰀨
• To use this function, set "Input Selector" beforehand.
 Output Zone (Default Value: Main)
Select the zone where you want to listen to the music.
• To use this function, set "Input Selector" beforehand.
Main Outputs audio only to the main room (where this unit is
located).
Zone 2 Outputs audio only to the separate room (ZONE 2).
Main/Zone 2 Outputs audio to both the main room and separate room
(ZONE 2).
 Preset Volume (Default Value: Main=Last / Zone 2=Last)
You can set the volume beforehand for playing back the Sonos Port. You
can set volumes for the main room (where this unit is located) and separate
room (ZONE 2) respectively. Select a value from "Last" (Volume level before
entering standby mode), "Min", "0.5" to "99.5" and "Max".
• To use this function, set "Input Selector" beforehand.