62
Playback
Playing Back (ZONE 2)
Note
• To output audio from an externally connected AV component to ZONE 2,
use an analog audio cable for connection. Note that ZONE 2 output is not
possible with the connection using an HDMI cable, digital coaxial cable, or
digital optical cable
• You can only select the same source for the main room and separate room
with the "NET" and "BLUETOOTH" input selectors. Furthermore, if you have
"NET" selected in the main room and you then select "BLUETOOTH" in the
separate room, the main room will also switch to "BLUETOOTH".
•
room with AM/FM broadcasts. (North American models)
• DSD audio signals cannot be output to ZONE 2 with the "NET" input selector.
• If ZONE 2 is on, power consumption during standby will increase.
•
Bluetooth wireless technology enabled devices" ( →p42).
Turning ZONE 2 On/O
1. Press REMOTE MODE ZONE 2 once on the remote controller.
• The remote controller switches to the mode for controlling ZONE 2.
2. Press ON/STANDBY on the remote controller. "Z2" lights in the main
procedure.
1 21
• To control on the main unit, press the ZONE 2 button twice on the main unit to
that is next to it.
• When the power of this unit is switched to standby while using ZONE 2, the
Z2 indicator lights dimly, and the mode switches to play only in the separate
room. Furthermore, the mode switches to play only in the separate room
when this unit is in standby mode and ZONE 2 is turned on.
To Next Page
Loading...
