45
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Preparation
≫
Playback
≫
Setup
≫
Tuning Manually
1. Press TUNER to switch to "TUNER" input.
2. Press BAND repeatedly to select either "AM" or "FM ST".
3. Press TUNING +/– to select the desired radio station.
• Each time you press TUNING +/–, the frequency changes by 1 step. If the
button is held down, the frequency changes continuously.
Improving FM reception
When FM broadcasts reception is poor, set the receiver to the mono reception
mode.
1. Press BAND to select "FM MONO".
Frequency step setting (Australian models)
If you nd that you can't tune into stations successfully, the frequency step may
not be suitable for your country/region. In such a case, select a frequency step
suitable for your region.
1. Set the unit to standby mode.
2. While pressing and holding the TUNING button of the main unit, press the
ON/STANDBY button to turn the unit on. Each time you operate, the setting is
switched between "9 kHz/0.05 MHz" and "10 kHz/0.1 MHz".
• Default: 9 kHz/0.05 MHz
• This operation is not possible if "Control" and "Standby Through" are set to
other than "OFF".
❏ Presetting a Radio Station ( p46)
To Next Page
Loading...
