Onkyo TX-SR383

75
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Preparation
≫
Playback
≫
Setup
≫
❏ "USB Error 4 (I/U ERR4)" appears on the display.
• The power requirements of the USB device are too high for this receiver. Switch o󰀨 the receiver and reconnect the USB to the receiver.
 Multi-zone function
❏ Cannot ZONE-output the audio of externally connected AV components
• To output audio to ZONE 2, you need to set "2. Manual SP Setup" - "a. Speaker System" to "ZONE 2" on the setup menu.
• To output audio from an externally connected AV component to ZONE 2, use an analog audio cable for connection.
( p61)
( p18)
 Remote Controller
• Make sure that the batteries are inserted with the correct polarity.
• Insert new batteries. Do not mix di󰀨erent types of batteries, or old and new batteries.
• Make sure that the sensor of the main unit is not subjected to direct sunlight or inverter-type uorescent lights. Relocate it if necessary.
• If the main unit is installed in a rack or cabinet with colored-glass doors, or if the doors are closed, the remote controller may not work normally.
 Display
❏ The display does not light up
• When the Dimmer function is working, the display may go dim. Press the DIMMER button, and change the brightness level of the display. ( p10)
 Others
❏ Strange noise can be heard from the unit
• If you have connected another device to the same outlet as this unit, strange noise may occur under the inuence of the device. If the symptom is
remedied by removing the power plug of the other device from the outlet, use di󰀨erent outlets for this unit and the device.
❏ The measurement results of AccuEQ Room Cal. show di󰀨erent distances to the speakers from the
actual ones
• Depending on the speakers you are using, measurement results may di󰀨er from the actual distance.
❏ "OVERHEAT" appears in the display and the volume level drops.
• The temperature within the unit has exceeded the allowable value. Try moving the unit for better ventilation.
• Lower the volume level.