Chapter 7: Alerts and Logging
160 Console Server & RIM Gateway User Manual
7.4 Resolve Actions
Actions can also be scheduled to be taken a trigger condition has been resolved:
For a nominated Auto-Response - with a defined trigger Check Condition - click on Add Resolve Action (e.g.
Send Email or Run Custom Script) to select the action type to be taken
Note: Resolve Actions are configured exactly the same as Trigger Actions except the designated Resolve Actions are
all executed on resolution of the trigger condition and there are no Action Delay Times set
7.5 Configure SMTP, SMS, SNMP and/or Nagios service for alert notifications
The Auto-Response facility enables remote alerts to be sent as Trigger and Resolve Actions. Before such alert
notifications can be sent, you must configure the nominated alert service.
7.5.1 Send Email alerts
The console server uses SMTP (Simple Mail Transfer Protocol) for sending the email alert notifications. To use SMTP, the
Administrator must configure a valid SMTP server for sending the email:
Select Alerts & Logging: SMTP &SMS
In the SMTP Server field enter the IP address of the outgoing mail Server
If this mail server uses a Secure Connection, specify its type. You may also specify the IP port to use for SMTP.
The default SMTP Port is 25.
To Next Page
Loading...