Opengear ACM5000 - Authentication; Network Hosts

Console Server & Router User Manual 251
14.1.4 Authentication
To change the type of authentication for the console server:
# config -s config.auth.type='authtype'
'authtype' can be:
Local
LocalTACACS
TACACS
TACACSLocal
TACACSDownLocal
LocalRADIUS
RADIUS
RADIUSLocal
RADIUSDownLocal
LocalLDAP
LDAP
LDAPLocal
LDAPDownLocal
To configure TACACS authentication:
# config -s config.auth.tacacs.auth_server='comma separated list' (list of remote authentiction and authorization
servers.)
# config -s config.auth.tacacs.acct_server='comma separated list' (list of remote accounting servers. If unset,
Authentication and Authorization Server Address will be used.)
# config -s config.auth.tacacs.password='password'
To configure RADIUS authentication:
# config -s config.auth.radius.auth_server='comma separated list' (list of remote authentiction and authorization
servers.)
# config -s config.auth.radius.acct_server='comma separated list' (list of remote accounting servers. If unset,
Authentication and Authorization Server Address will be used.)
# config -s config.auth.radius.password='password'
To configure LDAP authentication:
# config -s config.auth.ldap.server='comma separated list' (list of remote servers.)
# config -s config.auth.ldap.basedn='name' (The distinguished name of the search base. For example: dc=my-
company,dc=com)
# config -s config.auth.ldap.binddn='name' (The distinguished name to bind to the server with. The default is to
bind anonymously.)
# config -s config.auth.radius.password='password'
The following command will synchronize the live system with the new configuration:
# config -r auth
14.1.5 Network Hosts
To determine the total number of currently configured hosts:
# config -g config.sdt.hosts.total
Assume this value is equal to 3. If you add another host, make sure to increment the total number of hosts from 3 to 4:
# config -s config.sdt.hosts.total=4
If the output is config.sdt.hosts.total then assume 0 hosts are configured.