Chapter 14: Command Line Configuration
260 Console Server & RIM Gateway User Manual
# config -s config.alerts.alert2.alarmrange.mon.from.hour=0
# config -s config.alerts.alert2.alarmrange.mon.from.min=0
# config -s config.alerts.alert2.alarmrange.mon.until.hour=0
# config -s config.alerts.alert2.alarmrange.mon.until.min=0
The following command will synchronize the live system with the new configuration:
# config -r alerts
14.1.14 SMTP & SMS
To set-up an SMTP mail or SMS server with the following details:
Outgoing server address mail.opengear.com
Secure connection type SSL
Sender John@opengear.com
Server username john
Server password secret
Subject line SMTP alerts
# config -s config.system.smtp.server=mail.opengear.com
# config -s config.system.smtp.encryption=SSL (can also be TLS or None )
# config -s config.system.smtp.sender=John@opengear.com
# config -s config.system.smtp.username=john
# config -s config.system.smtp.password=secret
# config -s config.system.smtp.subject=SMTP alerts
To set-up an SMTP SMS server with the same details as above:
# config -s config.system.smtp.server2=mail.opengear.com
# config -s config.system.smtp.encryption2=SSL (can also be TLS or None )
# config -s config.system.smtp.sender2=John@opengear.com
# config -s config.system.smtp.username2=john
# config -s config.system.smtp.password2=secret
# config -s config.system.smtp.subject2=SMTP alerts
The following command will synchronize the live system with the new configuration:
# config -a
14.1.15 SNMP
To set-up the SNMP agent on the device:
# config -s config.system.snmp.protocol=[ UDP | TCP ]
# config -s config.system.snmp.trapport='port number' (default is 162)
# config -s config.system.snmp.address='NMS IP network address'
# config -s config.system.snmp.commnity='community name' (v1 and v2c only)
# config -s config.system.snmp.engineid='ID' (v3 only)
# config -s config.system.snmp.username='username' (v3 only)
# config -s config.system.snmp.password='password' (v3 only)
# config -s config.system.snmp.version=[ 1 | 2c | 3 ]
The following command will synchronize the live system with the new configuration:
# config -a
To Next Page
Loading...
