Console Server & Router User Manual 257
# config -s config.devices.device8.connections.connection1.type=[serial | Host | UPS | RPC]
# config -s config.devices.total=8 (decrement this value when deleting a managed device)
To delete the above managed device:
# config -d config.devices.device8
The following command will synchronize the live system with the new configuration:
# config -a
14.11.12 Port Log
To configure serial/network port logging:
# config -s config.eventlog.server.address='remote server ip address'
# config -s config.eventlog.server.logfacility='facility'
'facility' can be:
Daemon
Local 0-7
Authentication
Kernel
User
Syslog
Mail
News
UUCP
# config -s config.eventlog.server.logpriority='priority'
'priority' can be:
Info
Alert
Critical
Debug
Emergency
Error
Notice
Warning
Assume the remote log server needs a username 'name1' and password 'secret':
# config -s config.eventlog.server.username=name1
# config -s config.eventlog.server.password=secret
To set the remote path as '/opengear/logs' to save logged data:
# config -s config.eventlog.server.path=/opengear/logs
# config -s config.eventlog.server.type=[none | syslog | nfs | cifs | usb]
If the server type is set to usb, none of the other values need to be set. The mount point for storing on a remote USB
device is /var/run/portmanager/logdir
The following command will synchronize the live system with the new configuration:
# config -a
14.1.13 Alerts
You can add an email, SNMP or NAGIOS alert by following the steps below.
The general settings for all alerts
To Next Page
Loading...
