User Manual
Advanced Console Server & RIM Gateway User Manual 199
Currently, the only LDAP directory service that supports group provisioning is Microsoft Active Directory. Support is
planned for OpenLDAP at a later time.
To enable group information to be used with an LDAP server:
 Complete the fields for standard LDAP authentication including LDAP Server Address, Server Password, LDAP
Base DN, LDAP Bind DN and LDAP User Name Attribute
 Enter memberOf for LDAP Group Membership Attribute as group membership is currently only supported on
Active Directory servers
 If required, enter the group information for LDAP Console Server Group DN and/or LDAP Administration
Group DN
A user must be a member of the LDAP Console Server Group DN group in order to gain access to the console and user
interface. For example, the user must be a member of ‘MyGroup’ on the Active Server to gain access to the console
server.
Additionally, a user must be a member of the LDAP Administration Group DN in order to gain administrator access to the
console server. For example, the user must be a member of ‘AdminGroup’ on the Active Server to receive administration
privileges on the console server.
 Click Apply.
 Ensure the LDAP service is operational and group names are correct within the Active Directory
To Next Page
Loading...
Need help?
General
